# # this config file was automatically generated # using lirc-0.6.3(parallel) on Tue May 29 01:33:21 2001 # # contributed by Jordan Hazen # # brand: Hughes # model: HIRD-B2 DSS satellite receiver # First segment: Control buttons (all but numbers & channel up/down) -- begin remote name b1 bits 26 flags SPACE_ENC|CONST_LENGTH eps 30 aeps 100 header 9176 4391 one 673 1591 zero 673 454 ptrail 672 repeat 9171 2145 pre_data_bits 3 pre_data 0x1 post_data_bits 3 post_data 0x7 gap 109121 toggle_bit 0 begin codes last 0x00000000021BED12 guide 0x00000000021BE916 up 0x00000000021BF30C down 0x00000000021BE11E left 0x00000000021BE51A right 0x00000000021BFD02 select 0x00000000021BE31C action 0x00000000021BEE11 list 0x00000000021BF10E info 0x00000000021BF906 back 0x00000000021BFE01 power 0x00000000021BF50A end codes end remote # Second segment: Numbers, channel up/down -- # (couldn't get these to work without separating them into a separate 'remote' # file) # # Despite the slow user interface of this old Hughes receiver, it can accept # full 3-digit channel numbers as fast as LIRC can send them. So, sequences # like 'rc SEND_ONCE b2 8 3 8' work fine. It will have changed channels # before the OSD catches up. begin remote name b2 bits 12 flags SPACE_ENC|CONST_LENGTH eps 30 aeps 100 header 9229 4355 one 695 1574 zero 695 428 ptrail 679 repeat 9170 2146 pre_data_bits 16 pre_data 0x30DF post_data_bits 4 post_data 0xF gap 108143 toggle_bit 0 begin codes 1 0x0000000000000A05 2 0x0000000000000609 3 0x0000000000000E01 4 0x000000000000010E 5 0x0000000000000906 6 0x000000000000050A 7 0x0000000000000D02 8 0x000000000000030C 9 0x0000000000000B04 0 0x000000000000020D ch- 0x0000000000000C03 ch+ 0x000000000000040B end codes end remote